|
RESAWS::BANDMILLS::CARRIAGES::EDGER/GANGS::TRIMMERS::REBUILDS/USED::CONTACT::JOBS::ABOUT US Call us at 1-800-558-3868 or E-mail us at csrfss@execpc.com |
|
|
Bedplate made for six post foundation for superior stability. Alignment pads are machined on bedplate and leveling screws provided for easier installation. Bedplate is open for additional height for off bearer position. Bedplate and column keyed for accurate alignment in field. Column in box sections with extra large bearings for sliding posts. Top and bottom wheels lapped to wheels with safety collar and taper for true operation. Top wheel is one piece Ductile Iron casting statically and dynamically balance. Lower wheel with extra heavy rim for flywheel effect. All arbor bearing factory adjusted. Stock size. Extra heavy and interchangeable. Strain knife edges with reduced pressure to provide minimum maintenance. Strain system is F&S knife edge type proven in field for great sensitivity and minimum maintenance. Upper wheel tilt independent of strain mechanism and supported on antifriction thrust bearings. Support for wheel grinder furnished with
bandmill. Strain system with locking arrangement so top wheel can be ground on true center of shaft. All strain parts on outside of mill. Strain weight with spring cushion to minimize inertial effect of weight. Upper saw guide swinging type. All guide blocks are interchangeable. Cartridge type guides optional. Counterbalance for upper guide operation not required. Spring take-up on guide slide to compensate for wear.
Top of Page
|
|
Please report any problems encountered on this website to: gURlgeek@ctcweb.net. |
F I L E R & S T O W E L L
All major weldments are made extra heavy for rigidity and are
oven stress relieved and sand blasted after welding.